ACTi GNR-3000 Manual do Utilizador descarregar pdf (Página 72)

www.acti.com

GNR-3000 System Administrator’s Manual

Configure Device Settings

After adding a device to NVR, you may continue to configure its video, motion detection, PTZ

or preset tour settings on Setup pageDevices tab. In this section, we will guide you through

how to configure these settings and their corresponding functions.

Configure Video Format

Go to Setup page Device tab, select a device from Device List, and then go to Video tab to

configure the video format of the stream output from this device. If the device is currently in

Dual Stream mode, you may switch the stream in live view window by click on the switch

below and configure individual settings for Media 1 and Media 2.

Video Settings Attributes

Field Name

Description

TV Standard

Default is NTSC

Stream Mode*

Select one of the streaming modes this device supports

Mounting Type*

Select the mounting position

Installation Angle*

Input the angle for a device mounted on the wall

Video encoder

Select one of the codec this device supports

Resolution

Select one of the resolutions this device supports

Video Quality*

Select your desired video quality of the image

Frame Rate(fps)

Select the (Frames Per Second) this device supports.

Maximum Bitrate

This puts a hard cap on the maximum bit rate allowed in any given

second of streaming. Assigning a limited bit rate may cause a few

dropped frames when the stream data overflows the allowed bit rate.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 149 150

Sem comentários

ACTi GNR-3000 Manual do Utilizador Página 72