ACTi D42A Manual Página 1

Bullet Camera Series Hardware Manual D41A, D42A, E47 Ver. 2014/03/27

Hardware Manual 10 Item Description 7 Digital Input / Output Connects to digital input or output devices, such as an alarm trigg

Hardware Manual 11 Mounting Options In areas with fierce weather conditions, the light bundled bracket can be replaced by a heavy

Hardware Manual 12 Installation Procedures Using the Bundled Bracket Step 1: Install the Bundled Bracket 1. Mark the location of

Hardware Manual 13 Step 2: Attach the Sunshield The use of sunshield is optional if the camera will be installed indoors. However,

Hardware Manual 14 Step 3: Install the Camera 1. If necessary, install a memory card to the camera. See How to Insert the Memory

Hardware Manual 15 Step 4: Waterproof and Connect the Cable The camera and the pre-installed network cable, “pigtail”, are resista

Hardware Manual 16 How to Use the Cable Gland This section describes how to waterproof the cable-out or “pigtail” of the camera us

Hardware Manual 17 2. Insert the clamping nut into the Ethernet cable. 3. Insert the sealing insert with claw. 4. Insert

Hardware Manual 18 6. Connect the Ethernet cable connector to the “pigtail” connector. 7. Attach the gland body to the “pigtail

Hardware Manual 19 How to Use the Conduit Gland This section describes how to waterproof the cable-out or “pigtail” of the camera

Hardware Manual 2 Table of Contents Precautions 4 Safety Instructions ...

Hardware Manual 20 2. Pull the Ethernet cable through the flex conduit. Leave enough length of the cable outside the flex conduit

Hardware Manual 21 6. On the “pigtail” side, insert the washer into the “pigtail”. 7. Connect the Ethernet cable connector

Hardware Manual 22 9. Push the flex conduit and insert the sealing nut into the gland body. NOTE: Make sure the clamping nut

Hardware Manual 23 Step 5: Connect the Cable Connect the other end of the network cable to a switch or injector. Then, connect the

Hardware Manual 24 Other Connections This section describes the procedures in connecting Digital Input and Output (DI/DO) and Audi

Hardware Manual 25 Understanding the DI/DO Cables You can connect up to one (1) DI and one (1) DO device to your camera. Digital

Hardware Manual 26 Typical Connection Based on these specifications, if the DI device has a voltage of 0V ~ 30V or the DO device h

Hardware Manual 27 The illustration below is a graphic example of connecting a relay to a high voltage DO device. Relay (DO1 Devi

Hardware Manual 28 Adjustments and Accessories This section describes the procedures on installing a memory card and resetting the

Hardware Manual 29 3. When done, ensure the rubber seal is aligned and attached to the back cover and then close the back cover b

Hardware Manual 3 Accessing the Camera 32 Configure the IP Addresses ...

Hardware Manual 30 Adjust the Viewing Angle and Focus The camera already comes pre-focused when taken out of the box. If there is

Hardware Manual 31 How to Reset the Camera In case there is a need to reset the camera to its default factory settings, do the fol

Hardware Manual 32 Accessing the Camera Configure the IP Addresses In order to be able to communicate with the camera from your PC

Hardware Manual 33 If you work with our cameras regularly, then there is even a better way to discover the cameras in t

Hardware Manual 34 Using the Default Camera IP Address If there is no DHCP server in the given network, the user may have to assig

Hardware Manual 35 Manually adjust the IP addresses of multiple cameras: If there are more than one camera to be used in the same

Hardware Manual 36 Access the Camera Now that the camera and the PC are both having their unique IP addresses and are under the sa

Hardware Manual 37 The following examples in this manual are based on Internet Explorer browser in order to cover all functions of

Copyright © 2014, ACTi Corporation All Rights Reserved 7F, No. 1, Alley 20, Lane 407, Sec. 2, Ti-Ding Blvd., Neihu Dis

Hardware Manual 4 Precautions Read these instructions You should read all the safety and operating instructions before using this

Hardware Manual 5 Federal Communications Commission Statement This equipment has been tested and found to comply with the limits f

Hardware Manual 6 Safety Instructions Don’t open the housing of the product Cleaning Disconnect this video product from the power

Hardware Manual 7 Introduction List of Models This hardware manual contains the following models: D41A 1MP Bullet with D/N, Adapt

Hardware Manual 8 Package Contents Camera Conduit Gland Cable Gland Washer Mounting Screw Kit Sunshield Screw Kit Bracke

Hardware Manual 9 Physical Description Item Description 1 Memory Card Slot Insert a memory card (not included) into this slot